INSTALLATION

1) Remove or retract your antenna. If you have a fixed antenna, you will need to make a small hole in your cover for it. (you will find related instruction on file name "Tips of Car Cover Usage)

2) Pull your cover over the roof from the back to the front.

3) Drop your cover over the sides, then fit the elastic hem of your cover under the front bumper of your vehicle. Secure your cover under the rear bumper and corners.

4) To Secure your cover on your vehicle, there's one set of buckle & straps on the bottom of the cover. Toss the buckle strap under the vehicle to the opposite side, clasp the buckle and fasten it.

5) You can also use the supplied cable lock for extra security. (UHD cover only)

REMOVAL INSTRUCTIONS

1) Release both ends of the cover from under the bumpers.

2) Fold up both sides onto the top of the vehicle into a long pile.

3) Start at the front of the vehicle and fold the cover from the front to the back.

Care

• Clean your cover with a soft brush and lukewarm water or machine wash in COLD water.
• DO NOT USE SOAP as it may remove the protective coating added by the factory.
• Line dry only; do not machine dry.
• Avoid trapping moisture under your cover. If your vehicle is outside for long periods or under snow, trapped moisture can sometimes cause paint to become cloudy. We recommend removing your cover every 30 days. Let your vehicle dry completely before reinstalling your cover.

Antennas

• Check your antenna - many antennas simply unscrew at their base. If your antenna cannot be removed or retracted, you will need to make a small hole in your cover for it.
• Put your cover on as much of your vehicle as you can without covering the antenna.
• Mark the area where your cover will go over the antenna.
• With a sharp pencil or pen, carefully push a small hole in your cover.
• Peel the backing from your antenna patch and centering the hole in the patch over the hole in your cover, adhere the patch to your cover.
• Press the patch down firmly.
• Carefully lift your cover down over your antenna, threading your antenna through the hole, and finish fitting your cover

Storage

• A Drawstring storage bag is provided for your cover. Be sure the cover is completely dry before you store it in the storage bag for an extended period.

More Information

• DO NOT cover a repainted vehicle immediately. Check with your painter or body shop for recommended cure time. Premature use of cover in this situation could cause damage to repainted surfaces or lacquer paint. The seller is not liable for this damage.
• When using this cover in high wind areas (and prolonged storage), use the loops and rope provided to securely pull the cover tight under the center of the car. The cover is not designed to replace a garage and should be checked for flapping in high winds. If the wind gets under the cover it can cause it to work loose and come off the vehicle.
• In very rare cases when a heavy rainstorm is followed by an extreme temperature drop to below freezing, it is possible for the cover to become frozen to a layer of ice created between the vehicle body and the cover. DO NOT attempt to remove the cover if this happens. If it is necessary to remove the cover, taking care to inspect the surfaces of both the cover and the vehicle during the removal process. Stop immediately if you encounter resistance - the ice has not been melted completely and you must pour more warm water over the vehicle.

• Never Cover a wet vehicle
• Not liable for repainted surfaces or lacquer paint
• Do not cover the tailpipe or exhaust
• A hot exhaust and muffler can burn you and melt your cover
• Be sure the hood and engine are cool before you put on your cover
• Never cover a convertible with the top down
• Do not spread cover across an open sunroof or t-roof
• DO NOT use a cover while trailering a vehicle
• This cover is designed to be water-resistant and repellent but it will not prevent water from reaching the surface of your vehicle.
• No charging port access except tesla 3 & Y